Scope Of Delivery; Introduction; Safety Instructions; Guarantee And Limitation Of Liability - Multiplex MULTIGyro G3 Mode D'emploi

Content
Scope of delivery
1. Introduction
1.1 Safety instructions
1.2 Guarantee and limitation of liability
2. Overview MULTIGyro G3
2.1 Overview LED display
3. Features
4. Technical data
5. Prior to start-up

Scope of delivery

· 1 gyro system · 4 connecting cables

1. Introduction

Congratulations on purchasing your MULTIGyro G3 - gyro
system for surface models. This manual contains important
information that will help you get the best from your gyro system.

1.1 Safety instructions

· Pay attention to correct polarity when connecting the servos
and the signal inputs.
· Damage due to incorrect voltage: Make sure that all the
connected remote control components are rated for the
same voltage as your MultiGyro G3. Excessive voltage may
destroy the gyro and cause your model to crash.
· Only use the gyro for its intended purpose.

1.2 Guarantee and limitation of liability

MULTIPLEX Modellsport GmbH & Co.KG does not assume
any liability for loss, damage or costs which arise through
the improper use and operation of our products, or which are
connected with such operation in any way. As far as is legally
permissible, the obligation of MULTIPLEX Modellsport GmbH
& Co.KG to provide compensation for damages, on whatever
legal basis, is limited to the invoice amount of the quantity
of MULTIPLEX Modellsport GmbH & Co.KG goods that were
directly affected by whatever incident gave rise to the damage.
This does not apply if MULTIPLEX Modellsport GmbH & Co.KG
is obliged to accept unlimited liability in accordance with
mandatory law for deliberate or gross negligence.
Our products are covered by the currently valid statutory
guarantee regulations. If you wish to make a claim under
guarantee, please contact the model shop where you
purchased the product. The guarantee does not cover
malfunctions caused by the following:
8
8 6. MULTIGyro G3 installation
8 6.1 Assembly
8 6.2 Cabling
8 6.3 Model type selection
9 6.4 Gyro gain adjustment
9 6.5 3-way switch setting
9 6.6 Servo middle adjustment, neutral rudder position
9 6.7 Gyro direction adjustment
10
· 3 adhesive pads · Instructions in 5 languages
Please read all the instructions contained in this manual
carefully before using the gyro system.
· Ensure sufficient power input.
· Follow the installation instructions.
· Use of a gyro system results in control commands being sent
more frequently to the servo. This may lead to increased
wear of the servos. Check correct operation of the servos
regularly.
· Improper operation
· Maintenance that was performed incorrectly, late or not at
all, or performed by a non-authorized body
· Incorrect connections
· Use of non-original MULTIPLEX accessories
· Modi cations / repairs that were not carried out by MULTIPLEX
or a MULTIPLEX Service Centre
· Accidental or deliberate damage
· Faults due to normal wear and tear
· Operation outside the technical speci cations or in connection
with components from other manufacturers.
MULTIPLEX Modellsport GmbH & Co.KG
Westliche Gewerbestraße 1 · D-75015 Bretten-Gölshausen
Multiplex/HiTEC Service: +49 (0) 7252 - 5 80 93 33
10
10
10
11
11
11
12
12