Front Wheel Secondary Retention Devices; Front Wheel Installation - Britax BOB Gear DUALLIE REVOLUTION SE Manuel D'utilisation

3. Remove Wheel
Raise the wheel a few inches off the
ground and pull the wheel out of the
rear wheel attachment bracket.
ATTENTION!
If you have
the PRO model, see pg. 20 for
removing rear wheel.
FRONT WHEEL SECONDARY
RETENTION DEvICES
Your stroller fork utilizes secondary
wheel retention devices designed
to help keep the wheel from
disengaging from the fork if the
quick release is incorrectly adjusted
and tightened. The wheel can still
remain loose and wobbly even with
the secondary retention device
working if the quick release has
not been properly tightened and
adjusted. The secondary retention
devices are backup systems and are
not intended as a substitute for a
properly adjusted quick release. The
secondary retention devices on your
stroller are the integral type that are
formed into the outer faces of the
fork dropouts.
(Secondary Retention Devices)
Dropouts
IMpORTANT: Using your stroller
with an improperly adjusted and
tightened wheel quick release can
allow the wheel to vibrate, wobble
or become detached from the
stroller. This can result in serious
injury or death.
It is critical that you do not remove
or disable the secondary retention
devices. The secondary retention
devices can reduce the risk of the
wheel disengaging from the fork
if the quick release is not adjusted
and tightened correctly. Removing
or disabling the secondary
retention devices will void the
warranty.

FRONT WHEEL INSTALLATION

1. Rotate Quick Release Lever
Rotate quick release lever so that
it curves away from the wheel. This
places it in the FULLY OPEN position.
Quick Release Lever
FULLY OPEN FULLY CLOSED
9
UGA09B