Quick Release, Clamping Lever Function; Rear Wheel Installation - Britax BOB Gear DUALLIE REVOLUTION SE Manuel D'utilisation

QUICk RELEASE, CLAMpING
LEvER FUNCTION
The rear wheels are correctly clamped
in place by the force generated when
the clamping lever is closed and the
cam action pulls the axle against the
attachment bracket, securing it in place.
The front wheel is correctly clamped
in place by the force generated when
the quick release lever is closed and
the cam action pulls the lever housing
against one dropout, and pulls the
adjusting nut against the other dropout,
clamping the hub between the
dropouts.
The tension adjusting nut sets the
amount of clamping force. Turning
the tension adjusting nut in the
clockwise direction while preventing
the quick release lever from rotating,
increases the amount of clamping
force. Alternatively, turning the tension
adjusting nut counterclockwise, while
preventing the quick release lever
from rotating, reduces the amount of
clamping force. The tension adjusting
nut only needs minor adjustments to
provide the correct clamping force, less
than a half turn can mean the difference
between safe and unsafe clamping
force.

REAR WHEEL INSTALLATION

1. Unlock Parking Brake
Prior to installing the rear wheels,
position the parking brake in the
unlocked position.
2. Open Rear Wheel Clamping
Lever
Rotate the clamping lever into the
fully open position so it curves away
from the rear wheel attachment
bracket.
Tension Adjusting Nut
Rear Wheel
Clamping Lever
3. Insert Rear Wheel Stub Axle
Insert the rear wheel's stub axle into
the hole in the rear dropout. If the
axle does not slide in easily, loosen
the quick release tension adjusting
nut by hand. Re-insert the axle fully
into the rear dropout until the axle
shoulder or snap ring on the axle
comes in contact with the attachment
bracket.
Stub Axle
Rear Wheel
Attachment
Bracket
ATTENTION!
If you have the
PRO model, see pg. 20 for rear
wheel installation.
Folded Position
7
UGA09B