Britax BOB Gear DUALLIE REVOLUTION SE Manuel D'utilisation page 19

1. Adjust Brake Force
If correct brake force is not applied
when the brake lever is pulled to
within 1/2" of the handle bar, then the
brake cable will need to be
tightened. To tighten the cable,
loosen the lock ring on the brake
lever and turn the barrel adjuster in a
counter clockwise direction. Secure
the barrel adjuster in the new position
by tightening the lock ring against the
brake lever body.
Lock Ring
Barrel Adjuster
If the rear wheels do not spin freely
when the brake lever is in the
released position, then there is too
much brake force and the brake
cable will need to be loosened. To
loosen the cable, loosen lock ring
and turn the barrel adjuster in a
clockwise direction. Secure the barrel
adjuster by tightening the lock ring
against the brake.
Lock Ring
Barrel Adjuster
Continue these adjustments until
proper braking force is established
on at least one of the rear wheels.
2. Balance Brake Force
Identify the wheel that does not have
enough brake force. Locate the drum
brake barrel adjuster on that side.
Tighten the brake cable (as in step
one), until the brake force is equal to
that of the opposite wheel.
NOTE: Adjustment of the drum
brake barrel adjusters requires a
wrench.
Barrel Adjuster
Lock Ring
NOTE: There are lock rings on all
barrel adjusters to stop them from
changing their position. Always make
sure the lock rings are tightly fastened
after making adjustments.
NOTE: Ensure that all brake cable
ends are properly located in the
relevant hole of the barrel adjusters.
19
UGA09B