Removing Front Wheel - Britax BOB Gear DUALLIE REVOLUTION SE Manuel D'utilisation

2. Insert Front Wheel
When facing the front of the stroller,
insert the wheel between the fork
dropouts so that the axle firmly con-
tacts the top of the slots of the fork
dropouts.
Dropout
3. Adjust Quick Release Lever
To adjust the quick release, hold the
quick release cam lever in the FULLY
OPEN position with your right hand
as shown. Tighten the tension adjust-
ing nut with your left hand until it is
finger tight against the fork dropout.
Tension Adjusting Nut
4. Close Quick Release Lever
To properly close the quick release and
secure the front wheel in the dropouts,
confirm the axle is contacting the top
of the dropouts on both sides and the
wheel is centered left to right.
Dropouts
10
UGA09B
Quick Release Lever
Fork Blade
FULLY CLOSED
FULLY OPEN
While maintaining the wheel in this
position, rotate the quick release
upward and into the FULLY CLOSED
position. When properly closed, the
curve of the quick release will be
pointing toward the wheel and parallel
to the fork blade. To generate enough
clamping force it is necessary to wrap
your fingers around the fork blade
while closing the quick release lever.
The proper force required to close the
quick release lever should leave a visible
imprint in the palm of your hand.
IMpORTANT: It takes considerable
force to securely clamp the wheel.
If you are able to completely close
the quick release without wrapping
your fingers around the fork blade
and the quick release lever does not
leave a visible imprint in the palm
of your hand, the tension is not
adequate. Rotate the lever to the
FULLY OPEN position and turn the
tension adjusting nut a quarter turn
clockwise and repeat the closing
process.
If the quick release lever cannot
be rotated to the FULLY CLOSED
position, rotate the lever to the
FULLY OPEN position and turn the
tension adjusting nut a quarter
turn counterclockwise. Repeat the
closing process.

REMOvING FRONT WHEEL

1. Open Quick Release Lever
Move the wheel's quick release lever
from the locked or FULLY CLOSED
position to the FULLY OPEN position.
Your front fork has integral secondary
retention devices that require loosen-
ing the tension adjusting nut enough
to allow removal of the wheel.