Removing Rear Wheel - Britax BOB Gear DUALLIE REVOLUTION SE Manuel D'utilisation

4. Adjust Rear Wheel Clamping
Lever
To adjust the clamping lever, hold the
clamping lever in the FULLY OPEN
position with your right hand, and
tighten the tension adjusting nut with
your left hand until it is finger tight
against the attachment bracket.
To TIGHTEN tension adjusting nut,
turn clockwise.
To properly close the clamping lever
and secure the rear wheel in the
attachment bracket, confirm the axle
is fully inserted in the attachment
bracket, while maintaining the wheel
in this position, rotate the clamping
lever toward stroller and into the FULLY
CLOSED position.
To generate enough clamping force
it is necessary to wrap your fingers
around the attachment bracket while
closing the clamping lever. The proper
force required to close the clamping
lever should leave a visible imprint in
the palm of your hand.
If the clamping lever cannot be rotated
to the FULLY CLOSED position, rotate
the lever to the FULLY OPEN position
and turn the tension adjusting nut a
quarter turn counterclockwise. Repeat
the closing process.
8
UGA09B
FULLY CLOSED
IMpORTANT: It takes considerable
force to securely clamp the wheel.
If you are able to completely
close the clamping lever without
wrapping your fingers around
the attachment bracket and the
clamping lever does not leave
a visible imprint in the palm of
your hand, the tension is not
adequate. Rotate the lever to the
FULLY OPEN position and turn the
tension adjusting nut a quarter
turn clockwise and repeat the
closing process.
To LOOSEN tension adjusting nut,
turn counterclockwise.

REMOvING REAR WHEEL

1. Unlock Parking Brake
Prior to removing the rear wheels,
position the parking brake in the
unlocked position.
2. Open Rear Wheel Clamping
Lever
Move the wheel's clamping lever
from the locked or FULLY CLOSED
position to the FULLY OPEN position.
FULLY CLOSED
FULLY OPEN
FULLY CLOSED