Important - Britax BOB Gear DUALLIE REVOLUTION SE Manuel D'utilisation

IMPORTANT: Ensure that the gap
between the barrel adjuster and the
lock ring does not exceed 5mm. If
the gap exceeds 5mm, there is a
risk that the screw will shear with
potential loss of braking function.
5mm
3/16"
max.
Brake Backplate
Lock Ring
Barrel Adjuster
REAR WHEEL INSTALLATION
(pRO MODEL)
Follow steps 1 and 2 from (REAR
WHEEL INSTALLATION)
section on page 7.
3. Insert Rear Wheel Stub Axle
Insert the rear wheel's stub axle into
the hole in the rear wheel attachment
bracket. If the axle does not slide
in easily, loosen the clamping lever
tension adjusting nut by hand. Re-
insert the axle fully into the attachment
bracket until a "click" is heard. Adjust
tension nut and close clamping lever
as described in step 4 on page 8.
20
UGA09B
Stub Axle
REMOvING REAR WHEEL
(pRO MODEL)
Follow steps 1 and 2 from
(REMOVING REAR WHEEL)
section on page 7.
5mm
3/16"
3. Remove Wheel
max.
While pressing the rear wheel
retention button, raise the wheel a
few inches off the ground and pull
out from the rear wheel attachment
bracket.
IMpORTANT: Ensure there is a click
upon fully inserting the wheel. If no
click is heard, there is a possibility
that the wheel is not secure in the
attachment bracket and it may fall
off during operation.
CLICK
Rear Wheel
Retention Button
Rear Wheel
Attachment
Bracket