Adjusting The Material Volume - WAGNER WallPerfect W 985 E Mode D'emploi

WallPerfect W 985 E
•
Guide the material hose close along the spray head along to the grab handle and
push it into the guide rail (5).
•
Clip the cover (11) on to the spray head.
Connecting the hoses (fig. 6)
•
Insert the control hose (1) into the grab handle
•
Insert the thin end of the black air hose (3) into the grab handle (2) (watch out for
marking) and fix it into position by turning it to the right.
•
Insert the thick end of the air hose (3) into the air-hose connection (4) on the basic
device (watch out for marking) and fix it into position by turning it to the right.
•
Connect the material hose (5) to the material hose connection socket (6) and secure
with securing clip.
•
Connect the control hose (1) to the control hose connection socket (7).
•
Connect the suction hose (8) to the suction hose connection socket (9)and secure
with securing clip.
•
Plug the attachment clip on the suction hose (10) to the edge of the paint container.
•
Push the suction hose down to the base of the paint container.
Do not push the hose too far into the paint container, as it might otherwise
i
bend upwards and suck in air.
Brief explanation of functionality of the W985 E
In the W985 E the coating material is sucked directly out of the material container by a
pump. At the nozzle, the coating material is atomised with the help of the turbine and at
the same time wrapped with a coat of air.
Multifunction switch settings (fig. 2, A)
CLEAN The pump is ready for operation and is switched on by pulling the

trigger. The turbine is switched off.
Settings for cleaning and pre-filling the system
OFF Pump and turbine are switched off = system is off

ON Pump and turbine are ready for operation. The coating material is

moved and sprayed by pulling the trigger.
Operating setting

Adjusting the Material Volume

The material quantity is set depending on the characteristics of the material (viscosity)
and the working speed of the operator.
This setting can be made variably with the material flow limiter (fig. 2, B):
lower material
higher material
i
We recommend starting with a low material flow setting and then gradually
adjusting this to suit needs. .
turn to the left

turn to the right

GB
21