Preparation Of The Workplace; Preparation Of The Coating Material - WAGNER WallPerfect W 985 E Mode D'emploi

GB

Preparation of the workplace

Sockets and plugs must be masked. Risk of an electric shock as a
consequence of sprayed material entering the socket!
Mask all the areas and objects that are not to be spray painted, or
remove them from the work area.
Silicate paint corrodes glass and ceramic surfaces upon contact! All
such surfaces must therefore be completely covered.

Preparation of the Coating Material

Spray material that is at least at room temperature (e.g. diluted with warm
i
water) provides a better spray result.
Attention! Do not heat spray material above 40°C.
Make sure the material container is positioned stably to avoid knocking it
i
over by accident.
Using WallPerfect W 985 E interior wall paints can be applied by spraying without diluting
them, or by diluting them slightly. Detailed information is available in the technical data
sheet of the manufacturer ( Internet Download).
1.
Stir the material thoroughly and dilute it in the container as per the recommended
dilution (an agitator is recommended for stirring).
Sprayed material
Interior wall paint (dispersions and latex paint)
2.
If the feed rate is too low even at maximum flow setting, dilute in steps of 5 - 10 % until
the feed rate meets your requirements.
Assembling the spray lance (fig. 4)
•
Put air pipe (2) in grab handle (1).
After assembly, the air pipe and grab handle can no longer be separated.
i
Do not try to disassemble them by force!
•
Put together the spray head (3) and air pipe (2).
•
Unwind up the pull wire (4) and guide it along the guide rail (5), over the guide hook
(6) to the spray head.
•
Push back the trigger (7) and connect the pull wire. Set the pull wire at a tension using
the adjustment screw (8). (Fig. 4A)
Attention! Do not tighten the adjustment screw (8) too much. The
nozzle opening has to remain closed at this point (see fig. 5 A), as
otherwise material might leak out.
•
Push the end of the material hose (fig. 4 B, 9), without the clip, into the slot (fig. 4 B,
10) on the spray head.
20
Thinning recommendation
WallPerfect W 985 E
dilute by 0-10 %