Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
WallPerfect W 985 E
If the work being performed is of a sophisticated nature (e.g. the borders
i
around plugs) do not pull the trigger through completely. This prevents the
feed pump from being switched on and the only material that is sprayed is
the material that is already in the system. If this starts to run out, briefly pull
the trigger completely in order to refill the system.
i
"Cross spray" when using paint with a poor covering capacity or if the
surface is highly absorbent (Fig. 8).
i
Interior wall paint in strong colour shades should be applied at least twice
(allow first paint coat to dry first). This will ensure good coverage.
Interruption of Work
•
Turn the machine off. (Set the multifunction switch to "OFF")
•
Put the spray lance in the holder.
•
Wet paint surface in paint container with a little water to prevent a skin from forming.
•
Clean nozzle openings after an interruption in operation.
Taking Out of Operation and Cleaning
Proper cleaning is the prerequisite for problem-free operation of the paint application
device. No warranty claims are accepted in case of improper or no cleaning.
We recommend using hot water for cleaning purposes.
i
1)
Turn the machine off. (Set the multifunction switch to "OFF")
2)
Remove the suction hose from the paint container.
3)
Set the multifunction switch to "CLEAN".
4)
Hold the spray lance over the material container and pull the trigger to pump the
remaining paint out of the system into the material container.
5)
Turn the machine off. (Set the multifunction switch to "OFF")
6)
Place a container with water in front of the device and attach the suction hose.
7)
Click the spray lance into the holder and slew it over the container with water. (Fig.
10)
Attention! During automatic cleaning of the pump do not leave the
device unattended. The hoses could disconnect during the cleaning
operation leading to water damage.
8)
Set the multifunction switch to "CLEAN".
9)
Pull the trigger and push the stop upwards to secure the trigger. Allow water to
circulate through the machine for about 10 minutes in order to clean the pump and
hoses. If necessary renew the water.
10)
Release the stop by pulling the trigger.
11)
Turn the machine off. (Set the multifunction switch to "OFF")
12)
Take the spray lance out of the holder and remove the cover from the spray head.
GB
23
Publicité
Table des Matières
