Fuel Mixture - IKRA BT 2335 Manuel D'utilisation

SCALPING AND EDGING
Both of these applications are done with the line head
tilted at a steep angle. Scalping is removing the whole
top growth leaving the earth bare. Edging is trimming
the grass back where it has spread over a sidewalk or
driveway. During both edging and scalping, hold the
unit in a steep angle and in a position where cut-off
matter and any dislodged dirt and stones will not be
thrown towards you, even if it bounces back from a
hard surface. Although the picture shows both edging
and scalping every operator himself must find the an-
gles which suit his/her body size and cutting situation
best.
WARNING DANGER
Do not trim in areas where there are strands of fencing
wire. Always wear protective clothing and other protec-
tion equipment for your personal safety. Never cut in
areas where you cannot see what the cutting tool is
actually cutting.
Changing the spool
The cutting head consists of the following parts:
1 2
1 Spool housing
3 Spool
Hold the spool housing 1 firmly and turn the Tap'n go
button 4 clockwise until it can be removed. Remove
the used-up spool 3 from the spool housing. Pass the
two line ends of the new spool through the eyelets in
the spool housing as shown in the picture. The line
ends still stay clamped in the two transport clamps pf
the spool.
4
3
1
3
2 Spring
4 "Tap'n go" button
1
Put the line spool in the spool housing. Please turn
the spool such that the clamped line ends are located
directly in front of the eyelets of the spool housing.
Make sure that the spring 2 is properly seated under
the spool. Now place the Tap'n go button back on the
threaded bolt and screw it down by turning it clockwise.
Now vigorously pull on both line ends at the same time.
This will loosen them from the transport clamps of the
spool. The cutting head is now ready for operation.
You may also coil up the line yourself. If you do so, use
the required line with a diameter of 1.8 mm only.
Use 2 separate lines with a length of about 2.5 m each.
To fix the line ends the spool has 2 eyelets. Put the
end of each thread into an eyelet. Put the line into the
eyelet in the direction of the arrow as shown on the
bottom side of the spool. Put each line end in by about
2cm. Now grab both lines with one hand and concur-
rently coil them up in the direction of the arrow. Make
sure that each line is coiled up separately in its own
compartment and are not mixed up.
4

FUEL MIXTURE

WARNING
Never fill the fuel tank to the very brim. Do not fill the
tank with fuel in a closed, non-ventilated area. Do not
refuel the unit close to an open flame or sparks. Make
sure to wipe off spilled fuel before attempting to start
engine. Do not attempt to refuel a hot engine.
The fuel used for this model is a mixture of unleaded
petrol and approved engine lubricant. Use branded 89
octane or higher unleaded petrol known to be of good
quality. This will help to avoid possible damage to the
fuel lines and other engine parts.
2
MIXTURE RATIO 25:1
FUEL
The engine uses two-stroke fuel, a mixture of petrol
and 2-stroke lubricant with a ratio of 25:1.
GB-6
Finally, fix the line ends by
putting each in one of the
transport clamps as shown
in the picture. The spool
can now be installed. Pro-
ceed as described above to
install the spool.