Güde GTB Série Traduction Du Mode D'emploi D'origine page 25

Shaft and Chuck Assembling (Fig. 12)
1. Carefully clean the Morse taper and the chuck and keep them free of any traces of oil and dust. Now. fit
the Morse taper (1) in the chuck (2) with a jerk.
2. Put the chuck (3) on the taper drift short cone.
3. Close the chuck jaws completely. To prevent any damage to the chuck. put a small spanner in and knock
the taper and the chuck up with 2-3 slight hits.
WARNING: To avoid any damage to the chuck. do not use metal hammer for hammering the chuck on
the shaft.
Removal of Chuck (Fig. 13)
1. If the chuck is to be lowered completely. unloose the quill sleeve (1). Use the advancement hand lever to
do it. There big oval holes on both sides of the quill sleeve (2).
2. Rotate the chuck (3) until the quill hole (4) and the sleeve hole are in alignment
3. Insert the wedge (5) and knock it slightly with a hammer.
4. Both the shaft and chuck will fall down from the quill.
Drill Assembling (Fig. 14)
1. Mount your drill by means of two holes (1) in the base plate to a stand or a bench. using premium
assembling material. That should prevent any rollover. slip or shift of the machine in operation.
IMPORTANT NOTICE: When the stand or the bench begin to move while the drill is working. fix it
safely to the floor.
Fig. 11
Fig. 13
Fig. 12
Fig. 14
25