Welding - Virax VULCA P250 B PRO CNC Manuel D'utilisation

 Check, whether the pipes are resting firmly in the clamping elements, whether the welding areas are plane,
parallel and axially aligned.
Should the joint surfaces show any misalignment, repeat the trimming procedure. For best results the work
piece ends should not be mismatched by more than 10% of the wall thickness and the maximum gap between
the joint surfaces no more than 0.5 mm. This recommendation does not release you from your obligation to
observe national welding guidelines. Clear away any remaining shavings with a clean brush.
CAUTION! Do not touch the trimmed, ready to weld surfaces. Ensure that the surfaces are free of
any and all containments and foreign objects!

3.2.3. Welding

Risk of injury! Keep a safe distance from the machine when mechanically closing clamps and
moving work pieces. Keep hands, limbs and objects such as clothing, tools etc. away from
running machine!
The form shows the temperature of the heating plate.
The display bar shows up in blue if the temperature is too low, and in red when it is too high.
When it is in the target range, it displays as green.
The machine can only be run in the green target range.
 Insert the heating element between the two work pieces in the basic machine, and make sure that the
heating plate supports are seated in the notches of the removal device.
The arrow keys take the program back to "Drag pressure finding"
The arrow keys take the program back to "Please insert the trimmer..."
EXIT takes the program to the main menu without saving.
Page 43