Virax VULCA P250 B PRO CNC Manuel D'utilisation page 42


Switch on the milling unit by pressing the text field. The cutting disks must run in the cutting direction. If they
don't, use an appropriate tool to switch the phase inverter on the electrical plug.
Risk of serious injury! During operation trimmer unit, stay a safe distance away from the machine,
and do not reach into the rotating knife. Use trimmer in working position only and return it into
the designated carrying frame immediately after use. Ensure that the safety switch functions
properly at all times to avoid any accidental starting of the trimmer away from the basic machine.
 Clamping elements move together automatically. The cutting pressure can be increased with the rotary knob
(4). Standard cutting pressure is up to 20 bar, but it can be raised to 50 bar, see point 3.5.
An excessively high milling pressure can lead to overheating and damage to the miller drive. When
the milling drive is overloaded or at rest, raise the machine and reduce the pressure (s. 3.5).
 After the shavings with a chip thickness of < = 0.2mm are discharged continuously from the milling cutter,
press on text field. Milling unit is switched off and the clamping elements start up.
 Wait until the cutting disks have stopped. Remove the cutting unit from the basic machine and put it in the
storage case.
 Press text field, the work pieces move together and the drag flow pressure is measured
 The measured drag pressure will automatically be added to the equalization, warm-up and cutting pressure
Stay a safe distance away from the machine. Do not stand or reach into the machine. Keep
other people away from the work area.
The arrow keys take the program back to „Please insert the trimmer..."
EXIT takes the program to the main menu without saving.
Page 42