Virax VULCA P250 B PRO CNC Manuel D'utilisation page 41

Tube/raccord :
 For pipe-to-fitting connections, the two spacers must be engaged in both
middle clamping elements, and the heating element take-off device is suspended
into the left clamping elements.
Attention: Under no circumstances should the spacers be installed diagonally offset!
 The pipe is inserted into three clamping elements, and the fitting is held by one clamping element. Thus, the
movable clamping element can be shifted on the rod as space requirements demand during clamping.
When some fittings are being processed in certain positions, such as horizontal bends or welding necks, it is
necessary to remove the heating element take-off device.
 Start the welding process with GO.
In this final overview, the last changes can be made by clicking on the relevant subpoint and confirming with GO.
In CNC mode, control is executed by the touch PC. All functions outside the touch PC, except for the power key
(6), are blocked.
The welding process can be cancelled by the power key. The key lock is then raised and the relevant message
appears in the display.
Pressing the arrow key causes the machine to start up; pressing EXIT causes the program to spring into the main
menu without saving.
 Place the electrical cutting unit between the two work pieces to be welded.
 Switch on the miller motor and lock the switch in place.
Page 41