Technical Data; Rating Plate - Progress PAS8060E Notice D'utilisation

Problem
You cannot activate the out‐
er ring.
There is a dark area
on the multiple zone.
The sensor fields become
hot.
comes on.
comes on.
and a number come on.
E6 comes on.
If you cannot find a solution...
If you cannot find a solution to the problem
yourself, contact your dealer or an
Authorised Service Centre. Give the data
from the rating plate. Give also three digit
letter code for the glass ceramic (it is in
the corner of the glass surface) and an

TECHNICAL DATA

Rating plate

Model PAS8060E
Typ 60 HBD 47 AO
Ser.Nr. .................
PROGRESS
Possible cause
It is normal that there is a
dark area on the multiple
zone.
The cookware is too large or
you put it too near to the
controls.
Automatic Switch Off oper‐
ates.
The Child Safety Device or
the Lock function operates.
There is an error in the hob.
The second phase of the
power supply is missing.
error message that comes on. Make sure,
you operated the hob correctly. If not the
servicing by a service technician or dealer
will not be free of charge, also during the
warranty period. The instructions about
the Service Centre and conditions of
guarantee are in the guarantee booklet.
PNC 949 593 001 03
220 - 240 V 50 - 60 Hz
Made in Germany
7.0 kW
Progress 13
Remedy
Activate the inner ring first.
Put large cookware on the
rear zones if possible.
Deactivate the hob and acti‐
vate it again.
Refer to "Daily use" chapter.
Disconnect the hob from the
electrical supply for some
time. Disconnect the fuse
from the electrical system of
the house. Connect it again.
If comes on again, speak
to an Authorised Service
Centre.
Check if the hob is correctly
connected to the electrical
supply. Remove the fuse,
wait one minute, and insert
the fuse again.