FUST NOVOMATIC FH67-VCU Notice D'utilisation page 65

• Clean stubborn dirt with a special oven
cleaner.
• Clean all oven accessories (with a soft
cloth with warm water and cleaning
agent) after each use and let them dry.
• If you have nonstick accessories, do not
clean them using an aggressive agents,
sharp edged objects or dishwasher. It
can destroy nonstick coating!
Shelf Support Rails
Removing the shelf support rails
1. Pull the front of the shelf support rail
away from the side wall.
2. Pull the rear shelf support rail away
from the side wall and remove it.
Installing the shelf support rails
Install the shelf support rails in opposite se-
quence.
The rounded ends of the shelf support
rails must point to the front!
Cleaning the oven door
The oven door has two panels of glass in-
stalled one behind the other. To make the
cleaning easier remove the oven door and
the internal panel of glass.
Warning! The oven door can close if
you try to remove the internal panel of
glass when the door is still assembled.
Warning! Make sure that the glass
panels are cool, before you clean the
glass door. There is risk that the glass
breaks.
Warning! When the door glass panels
are damaged or have scratches, the
glass becomes weak and can break.
To prevent this you must replace them.
For more instructions, contact your
local Service Centre.
Removing the oven door and the glass
panel
1. Open the door fully and hold the two
door hinges.
2. Lift and turn the levers on the two hing-
es.
3. Close the oven door to the first opening
position (halfway). Then pull forward
and remove it from its seat.
65