Table des Matières
Publicité
EN
1) GENERAL FITTING INSTRUCTIONS
Before the preparation of the vehicle chassis and mounting of
the Hydraulic Tail Lift (named HTL hereafter), read and make
sure you understand the underlying fitting instructions first,
and progress step by step after that.
Before getting started, also take notice of the safety
instructions for repair and maintenance, included in
the user's manual issued with this HTL. In case of
doubt, and before making any further progress,
please consult your Dhollandia-agent.
After installation, perform the put-into-service test following
the check-list included in the user's manual, and fill-out the
CE Fitting Declaration in the same document.
Check the following points before getting started:
•
Check if the kit is complete, and if all parts needed to fit
the HTL correctly have been delivered.
•
Compare the voltage of the batteries of the vehicle with
the voltage of the hydraulic power pack of the HTL.
•
Compare the fitting dimensions given on the "FITTING
DRAWING" [See Fig. 1.1] with the actual dimensions of
the vehicle concerned . The actual floor height K should
not exceed the theoretical maximum lifting height of the
HTL, which depends on its arm-length.
•
Observe the FITTING AND BODY BUILDING
INSTRUCTIONS of the manufacturer of the
vehicle. Observe in particular the maximum
allowed HTL capacity, the instructions on the
use of hydraulic stabilising legs, the instructions
for mounting and bolting to the vehicle chassis,
and the manufacturer's guidelines for the elec-
trical interfaces [See Fig. 1.2].
DHOLLANDIA
1.1
EX.
7
1.2
Publicité
Table des Matières
