Migatronic LTE 200 S Manuel D'instruction page 18

MAINTENANCE
LTE type machines require little maintenance but
dusty and damp conditions are to be avoided
possible.
A recommended procedure at least once a year is
- to open the machine and clean all parts with dry,
compressed air.
- The fan blades should also be cleared and clea-
ned, and all terminals should be inspected and
cleaned or replaced if necessary.
- All mechanical connections on the electrical wires
can be sprayed with a silicon-based spray for
damp-proofing.
N.B. No other type of spray should be used.
Lack of maintenance can lead to reduced reliability
and cancellation of the guarantee.
All MIGATRONIC machines carry a twelve-month guarantee
if
against hidden defects. Such defects must be notified no
later than two months after it has been noticed. The warranty
runs for twelve months after invoicing to end customer.
The warranty covers material and manufacturing faults that
cannot be immediately acknowledged.
Lapse of warranty
The warranty covers no obvious product characteristics,
which in time are thought as being inconvenient.
Incorrect installation
The warranty does not cover defects due to incorrect
installation of the product, e.g. connection to the wrong mains
voltage.
Incorrect or abnormal use of the product
The warranty does not cover use of the product for other
purposes than it has been designed for. If the product is
used for more than 8 hours daily, the warranty does not
cover defects due to these intensive working conditions.
Lack of maintenance
There is a lapse of warranty if the product is not properly
maintained. E.g. if the product is dirty to such a degree that
cooling is hindered. The warranty does not cover damages,
which can be traced back to unauthorised and lacking repairs
of the product.
Over loading/extreme loading
The warranty does not cover over loading or extreme
loading. Nor transport damages, damages due to incorrect
handling, drops etc. The warranty does not cover abnormal
conditions as regards temperature, moisture or environ-
mental loading above the limit, which the machine has been
designed for.
Defects due to infestants
The warranty does not cover defects due to infestants.
Wear parts
The warranty does not cover parts of the product, which is
exposed to wear and tear, e.g. the wire drive rolls. The
warranty does not cover depreciation due to normal use, e.g.
scratches, rust and mechanical damage. Welding cables and
welding hoses are regarded as wear parts and therefore not
included in the warranty.
Resulting damages
Use of the product must stop immediately after acknowledge
of a defect in order to avoid further damage of the product.
The warranty does not cover resulting damages due to use
of the product after acknowledge of a defect. Moreover, the
warranty does not cover resulting damages on other items
due to product defect.
18
WARRANTY