Scratch Play; Spin Play; Jog Break Play; Effect Screen - Pioneer MEP-7000 Mode D'emploi

ADVANCED OPERATIONS SECTION
 To delete a cue point or loop information from
memory
1 Press the CUE/LOOP CALL button.
When the CUE/LOOP CALL button is pressed, the cue point or
loop information is called up, and the unit enters the standby
mode at the cue or loop-in point.
2 At the cue or loop point you wish to delete, hold the CUE/
LOOP MEMORY button depressed for one second or more.
The [MEMO] indicator will go out and the designated cue point
or loop point information will be deleted.
• The information can be deleted from the BROWSE screen as
well (P. 28).

SCRATCH PLAY

When the jog mode is set to [SCRATCH], pressing and rotating the
top surface of the jog dial will cause playback to be performed in
proportion to the direction and speed of jog dial rotation.
1 Press the SCRATCH button.
The SCRATCH indicator will flash blue.
2 During playback, press the surface of the jog dial.
Playback will stop.
3 Rotate the jog dial in the direction and at the speed you wish
for playback to occur.
Playback will begin in the direction and at the speed
corresponding to the jog dial input.
4 Release hand from surface of jog dial.
Playback will return to its original speed.

SPIN PLAY

During playback with the jog mode set to [SCRATCH], either press
the surface of the jog dial or the play/pause () button to set the
pause mode, then rotate the jog dial quickly; playback will proceed
in response to the direction and speed of jog dial rotation, even if
you remove your hand from the dial.

JOG BREAK PLAY

When the jog mode is set to [JOG BREAK], the pressing and
rotating the surface of the jog dial causes effects to be applied to
the sound in proportion to the direction of rotation and rotation
speed.
1 Press the JOG BREAK button.
The JOG BREAK indicator will flash red.
2 During playback, touch and press the surface of the jog dial.
3 Rotate the jog dial.
4 Release hand from surface of jog dial.
The effect will stop and sound will return to its original
condition.
• Jog break play is not enabled when DJS or other DJ software
tracks are loaded.

EFFECT SCREEN

When the EFFECT button is pressed, the center display will show
the EFFECT screen, providing graphic expression to assist with
scratch play and jog break play.
Function buttons
[1] Scratch effect
When the jog mode is set to [SCRATCH], the screen on the
controller side switches to scratch effect mode.
A blue ball will rotate in response to the track playback.
• The ball normally rotates to the right. When playback direction
changes, the ball reverses direction, and when playback stops,
the ball's rotation also stops.
1 During playback, press one of the function buttons
[SCRATCH/TRANS/BUBBLE].
EFFECT
39
En