Pioneer MEP-7000 Mode D'emploi page 41

ADVANCED OPERATIONS SECTION
[2] Jog break effect
When jog mode is set to [JOG BREAK], the screen on the controller
side switches to jog break effect mode.
MEMO
• The jog break effect mode is not supported when DJS or other
DJ software tracks are loaded.
1 During playback, press one of the function buttons [JET/
ROLL/WAH].
• The selected effect is shown in the center display, and the
respective effect is changed in response to the rotation of
the jog dial.
2 Effect HOLD
• Normally, when you remove your hand from the jog dial the
current effect stops and the also returns to its original
status. By pressing the select up () button is pressed on
controller A, or the select down () button on controller B,
even if the hand is removed from the jog dial, the effect
responding to the current position of the jog dial is
maintained (HOLD function). When the button is pressed
again, the function returns to normal.
• During HOLD, the JOG BREAK indicator will light red, and
the screen's [HOLD ON] indicator will light.
About JET
Delay time is changed in response to the jog dial rotation and a
short delay is mixed with the playback sound, thus producing
interference between the two sounds and resulting in a jet-like
"SCHWA—" sound effect.
In linkage to the effect the JET image animation is displayed
(WAVE display)
MEMO
• When you remove your hand from the jog dial, sound will
gradually return to the original sound.
About ROLL
In response to the rotation of the jog dial, the pitch and playback
time are changed, and effect applied to the playback sound.
MEMO
• The sound playing at the time the jog dial is touched is
continuously looped and roll is applied.
• When you remove your hand from the jog dial, the playback
returns to the original sound.
• In linkage to the effect, the ROLL image animation will be
displayed (a ball in orbit will appear; the orbit of the ball and its
speed will change in response to the rotation position and
direction of the jog dial.)
41
En