About The Lcd Screen; About Oel (Organic El) Screens - Pioneer MEP-7000 Mode D'emploi

TROUBLESHOOTING
Description of problem
MEP-7000 isn't detected when
connected to computer
(normal style connections).
MEP-7000 isn't detected when
connected to computer
(manipulator style
connections).
Television pictures are
distorted or noise appears in
FM broadcasts.
Disc is not rotating even
though power has been turned
on.
• There may be times when MEP-7000 fails to operate properly as a result of static electricity or some other form of interference
from an outside source. If any such problem occurs, turn off the power to the MEP-7000, wait for the currently inserted disc to
come to a full stop, and then turn on the power again to see if that fixes the problem in question.
• This unit cannot play "partial" (unfinalized) CD-R/-RW, DVD-R/-RW, DVD+R/+RW, and DVD±R dual layer media.
• Do not attempt to play irregularly shaped or other discs besides normal 12 cm round discs, since malfunction or damage may
result.
• The BPM value measured by MEP-7000 may differ from the BPM value recorded on a CD or from our DJ mixer, but this difference
is a result of differences in the BPM value measurement method; not a result of a fault with the player.

ABOUT THE LCD SCREEN

• Some LCD monitors may display so-called "hot pixels" or "dead pixels" (constantly bright pixels or pixels that are permanently
off). This is a phenomenon characteristic of LCD displays and is not considered a malfunction.
• When used in cold regions, the screen may appear dark for a while after the power is first turned on. As the unit warms up with
time, the screen will return to normal brightness.
• Avoid viewing the LCD screen in direct sunlight, since the light reflected off the screen may make the image difficult to view.

ABOUT OEL (ORGANIC EL) SCREENS

• The two screens (displays A/B) may display slightly different color characteristics, but this is not a malfunction.
66
En
Possible cause of problem
• Driver software hasn't been correctly installed in
computer.
If the MEP-7000 is not connected properly and
communicating with the computer, the version
information utility will not display the firmware
version. To check this, see P. 51 of this manual
("ABOUT THE DRIVER PROGRAM,
 Confirming the driver version").
• Control unit is connected to computer.
• Driver software hasn't been correctly installed in
computer.
If the MEP-7000 is not connected properly and
communicating with the computer, the version
information utility will not display the firmware
version. To check this, see P. 51 of this manual
("ABOUT THE DRIVER PROGRAM,
 Confirming the driver version").
• USB auxiliary power cable not connected.
• Interference caused by player.
• Disc rotation is automatically halted when no
operation is performed for 100 minutes or longer
when in pause mode.
• When the last track on the disc is over the disc
stops rotating.
Recommended action
• Install the driver correctly. If already installed, try
uninstalling and reinstalling it.
• In Normal Style, connect drive unit to computer.
• Install the driver correctly. If already installed, try
uninstalling and reinstalling it.
• Connect to computer in the order (1) USB
auxiliary power cable, and (2) USB cable.
• Turn off the power to the player or move the
player further away from the radio or television
set.
• Press the play/pause () button to begin
playback. Alternatively, press the EJECT ()
button to eject the disc.