Manipulator Style Connections - Pioneer MEP-7000 Mode D'emploi

CONNECTIONS

MANIPULATOR STYLE CONNECTIONS

These connections should be used when you wish to operate the accessory DJS or other DJ software without connecting the drive unit.
Use the accessory USB auxiliary power cable and the normal USB cable to connect the control unit to the computer (connect the USB
auxiliary power cable first).
Computer
NOTE
• When making manipulator style connections, do not connect the drive unit, since it will not function correctly.
• Do not connect anything to the 5 V connector other than the accessory USB auxiliary power cable.
• Always use the accessory USB auxiliary power cable and USB cable only.
• Always connect the accessory USB auxiliary power cable and USB cable to one and the same computer.
• Do not connect this unit to a computer through a USB hub.
• Do not connect this unit to a computer through a CardBus-supported USB interface card.
18
En
Accessory USB cable
Accessory USB auxiliary
power cable.
Audio interface (sold separately)
Audio cable
Mixer
PC
5V
MONITOR OUT
Do not connect until you have installed the required driver
in your computer. See "ABOUT THE DRIVER PROGRAM"
(P .49).
Control unit
REMOTE
CONTROL