Installation Of Pivot Mount - Cole-Parmer SD Mode D'emploi

Figure 7: Typical Mixer Setup using a Mixer Stand and Pivot Mount.
Note: The controller can be placed on any flat surface within 6 feet (183 cm) of the mixer motor
or can be mounted on a pivot mount (not supplied). Refer to the ACCESSORIES section for part
numbers.
To attach the pivot mount, proceed to the section below. If controller is placed elsewhere proceed
as follows:
6. Connect the 6 ft (183 cm) cable between the mixer motor and the controller rear panel.
7. Check that the controller is not powered. Ensure that the rear panel POWER switch is in the
OFF position.
8. Connect the 6 ft (183 cm) line cord from the controller to the appropriate 3-wire, grounded
power source.

Installation of Pivot Mount

Remove the two Phillips screws and lock washers on the bottom of the controller.
1.
Position Pivot Mount bracket over the bracket mounting holes, re-install the two Phillips screws
2.
and lock washers and tighten.
Attach a double (rod) clamp to the vertical support rod on the stand and position so that pivot
3.
mount bracket will be clear of mixer motor.
Slide the mounting rod of the pivot mount bracket into the double (rod) clamp or lower hole on
4.
the tank clamp. Tighten clamp.
Adjust position of controller by first loosening knob on pivot mount bracket, adjust position and
5.
then retighten knob.
Connect the 6 ft (183 cm) cable between the mixer motor and the controller rear panel.
6.
Check that the controller is not powered. Ensure that the rear panel POWER switch is in the
7.
OFF position.
Clamp
Controller
Pivot Mount
Mixer Stand
Mixer Motor
Keyless Chuck
Shaft
Propeller
12