Unpacking And Installation; Unpacking; Packing List; Location - Cole-Parmer 39457-00 Mode D'emploi

Unpacking and Installation

Unpacking

Each hybridization incubator is shipped in a single carton.
When unpacking the unit, check each item against the pack-
ing list below. If something is missing, contact customer serv-
ice at 1-800-323-4340, identifying the part by name and cata-
log number.
Part numbers are listed in the Replacement Parts and
Accessory Items sections located at the end of this manual.

Packing List

Quantity
Small Medium
1 1
1 1
1 1
1 1
1 1
2 2
1 1
1 1
1 1

Location

Follow these guidelines when choosing a location for the
hybridization incubator. The location must:
• Provide an adequate source of power. Check the
label on the back of the unit for voltage and current
requirements.
• Provide minimum air clearance as follows: 0.5 inch
(13 mm) from top, 2 inches (51 mm) from back, and
2 inches (51 mm) on each side.
• Provide adequate clearance for loading and unload-
ing samples.
Item supplied
Hybridization incubator
Drip tray
Rotisserie
35mm x 150mm hybridization tube
35mm x 300mm hybridization tube
Spare tube clips
Power cord
Instructions
Warranty card
9