Installation And Setup Procedures; Connecting Motor Cable To Controller - Cole-Parmer SD Mode D'emploi

Motor Connector
POWER Switch controls power to controller and motor.
C14 Connector is for power cable to mains.
Fan Filter
Mounting Hardware is accessible on the bottom to securely attach the Pivot Mount to the controller.
Fan Filter is removeable, washable for cleaning, and replaceable.

INSTALLATION AND SETUP PROCEDURES

Connecting Motor Cable to Controller

The Motor Cable connector has a locking mechanism when cable is connected. This is to prevent
unintended disconnection in the event of accidental force on the motor cable.
To ensure proper connection:
Orient the motor cable connector so the unlock icon and arrows are facing upward.
1.
Push the connector into the controller socket. The collar should rotate and return to its initial
2.
position, locking in the connection.
To disconnect the motor cable, rotate the blue collar counter-clockwise (left) to release the
3.
lock. The connector can now be pulled out of the socket, as shown in Figure 5.
Note: If controller display shows ERR3, the motor cable is not fully connected. Disconnect the
cable and reinsert into the controller.
C14 Connector
Figure 3: SD Controller Back Panel
Figure 4: SD Controller Bottom Panel
10
POWER Switch
Mounting Hardware
for Pivot Mount
Reusable Push-In Rivets