Charging Rechargeable Batteries; Charging The Drive Batteries For The Vehicle; Charging Rechargeable Batteries In The Transmitter - Reely Generation X 6S Notice D'emploi

8. Charging Rechargeable Batteries

a) Charging the Drive Batteries for the Vehicle
• The model is delivered without any drive batteries. They must be purchased separately. You can chose whether
you want to use low-cost battery packs for beginners or high-quality professional battery packs with a high capacity.
• Drive batteries are usually delivered uncharged and must be charged. Before the drive batteries reach their maxi-
mum capacity, several complete discharge and charge cycles are necessary.
For rechargeable batteries with LiPo technology, recharging partially discharged rechargeable batteries does not
cause any problems. Previous discharge is usually not required.
• High-quality rechargeable drive batteries not only have a higher capacity, which allows you to drive your model car
much longer, but also deliver a higher output voltage for extreme situations. This gives the motor more power and
results in better acceleration and higher speed.
• We recommend purchasing a high-quality charger. Such a charger usually has a quick-charging feature. If you want
to use a LiPo drive battery for your vehicle, the charger must have a balancer.
• Rechargeable batteries heat up during charging/discharging (driving the vehicle). Wait until the rechargeable batter-
ies have reached room temperature before charging them. The same applies after the charging procedure. Do not
use the rechargeable battery in the vehicle until it has cooled down sufficiently after the charging process.
• Only use a charger suitable for the battery type used (e.g. LiPo).
• Remove the drive batteries from the vehicle for charging and disconnect it from the speed controller completely.
b) Charging Rechargeable Batteries in the Transmitter
• The included transmitter may not have a charging socket; observe the included operating instructions for the trans-
mitter. In this case, remove the inserted batteries and charge them externally.
If your transmitter has a charging socket, check whether there are actually rechargeable batteries inserted
in the transmitter before connecting the charger. When charging normal (non-rechargeable) batteries, there
is a risk of fire and explosion!
• Rechargeable batteries in the transmitter must not be quick-charged, as this damages the transmitter and exces-
sively heats the cells inside the transmitter. Observe the maximum permissible charging current as indicated on the
transmitter or in the operating instructions of the remote control system.
• We do not recommend to charge batteries directly in the transmitter, it is better to charge them outside the transmit-
ter (using a high-quality charger for individual cells). Here, higher charge currents can be used depending on the
rechargeable batteries.
• Only use a charger designed for the respective number of cells in the transmitter and the corresponding recharge-
able battery type.
44