Choosing Walk Or Jog Mode; Checking Tire Pressure; Adjusting The Tracking - Britax BOB Gear REVOLUTION Guide De L'utilisateur

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Choosing Walk or Jog Mode

Walk Mode
Walk Mode
Slide swivel knob up and to the left.
Fork will now rotate 360 degrees.
NOTE: Stroller is shipped in walk
mode.
Jog Mode (Jogging/Off-Road)
Slide swivel knob upward and to the
right. Knob will slide into downward
position. Rotate fork/wheel until it
snaps into forward position.
If the front fork is in jog mode, it will
be locked and will not swivel left or
right as it does in walk mode.
IMPORTANT:
Never run, jog, or
walk fast with the stroller in walk
mode. Doing so could result in
loss of control and serious injury.

Checking Tire Pressure

Plastic wheels are rated to a
maximum tire inflation pressure of
30 pounds per square inch (psi).
The maximum inflation pressure is
embossed on the wheel next to the
valve stem.
Jog Mode
REVOLUTION User Guide

Adjusting the Tracking

If stroller pulls left or right when
the front wheel is in jog mode and
stroller is on flat terrain, adjust
tracking as outlined in the following
steps.
Do not roll test with a child or
any occupant in the stroller�
1� Empty Stroller
Remove contents from low boy
cargo basket and pockets.
2� Check Tire Pressure
3� Set Stroller to Jog Mode
Slide swivel knob to right. Knob
will slide into downward position.
Rotate fork/wheel until it snaps
into forward position. See
Choosing Walk or Jog Mode on
page 9.
4� Place Stroller On Level Ground
Find a stretch of level ground
about 16 feet (4.9 m) long.
5� Align Rear Wheel Axles
Align stroller so rear wheel axles
are perpendicular to a straight
line.
6� Test Alignment
Push stroller straight forward and
release to see if stroller veers right
or left. Repeat push test several
times.
If stroller consistently pulls to
left or right, see Fine Tuning the
Tracking.
16 ft (4�9 m)
90°
9

Publicité

Table des Matières
loading

Table des Matières