Britax BOB Gear REVOLUTION Guide De L'utilisateur page 8

BOB Gear by Britax
Rear Wheel Removal
1� Unlock Parking Brake
Prior to removing the rear wheels,
position the parking brake in the
unlocked position.
2� Remove Wheel
Raise the wheel a few inches off
the ground, pull the release lever,
and pull the wheel out of the rear
wheel attachment bracket.
Front Wheel Installation
1� Remove Through Axle From
Front Wheel
Unscrew the nut from the through
axle and remove the axle from the
front wheel.
2� Rotate Front Fork Into Jog
Mode
Rotate the front fork until it locks
into jog mode. See page 9.
6
3� Insert Front Wheel
When facing the front of the
stroller, insert the wheel between
the fork and align the wheel hub
with the holes in the fork blades.
4� Insert Through Axle
Insert the through axle into the
fork and through the wheel hub,
then install the tension adjusting
nut to the opposite side.
5� Tighten Tension Adjusting Nut
With the quick release lever in
the FULLY OPEN position, hand
tighten the tension adjusting nut
until secure.
Tension Adjusting Nut
6� Close Quick Release Lever
Lift up on the quick release lever
to lock into the FULLY CLOSED
position. When properly closed,
the quick release lever will be
parallel to the fork blade and
pointing up.
FULLY CLOSED
FULLY OPEN
Fork Blade