Connecting; Filling The Bean Container; Filling The Water Tank - Melitta Caffeo SOLO Manuel

4.2

Connecting

• Plug the power cable into an appropriate power socket.
Warning!
Danger of fire and electric shock due to incorrect supply voltage,
incorrect or damaged connections and power cord.
– Make sure that the supply voltage corresponds to the supply voltage
specified on the identification label of the appliance. The identification label
is on the right side of the appliance behind the cover (Fig. A, no. 11).
– Make sure that the power socket meets the applicable standards for
electrical safety. If in doubt, contact a qualified electrician.
– Never use damaged power cables (damaged insulation, bare wires).
– During the guarantee period, allow the damaged power cable to be
replaced only by the manufacturer; and only by qualified specialists after
the guarantee period is over.
4.3

Filling the bean container

• Remove the lid of the bean container and fill the container with fresh
coffee beans.
Caution!
– Fill the bean container with coffee beans only.
– Never fill the bean container with ground, freeze-dried, or caramelised
coffee beans.
• Place the lid on the container.
4.4

Filling the water tank

• Open up the flap of the water tank (Fig. A, no. 6) and pull the water tank
up and out of the appliance.
• Fill the water tank to the max. mark with fresh tap water and reinsert it.
Note
If the water tank runs empty during operation (e.g. during the coffee dispensing
process), the symbol for the water tank will be illuminated. The current
operation will be stopped and the water tank must be filled before starting a
new operation.
46 46