Melitta Caffeo SOLO Manuel page 73

Problem
The brewing unit
can no longer be
reinserted after
removal.
The buttons for
one- and two-cup
dispensing
flash alternately with
the ON/OFF button
.
Continuous flashing
of all buttons
Please contact the Melitta
solve the problem: +49 571/ 86 1900.
Cause
The brewing unit is not
properly locked.
The drive is not in the
proper position.
The brewing unit is
missing or is not properly
inserted.
The brewing chamber is
overfilled.
System error
hotline, if the above mentioned solutions do not help to
®
Solution
Check whether the handle
for locking the brewing unit is
correctly engaged.
Switch the appliance off and
on again, and then press
the buttons for one- and
two-cup dispensing
simultaneously for longer than
2 seconds. The drive moves
into position. Then reinsert the
brewing unit and make sure it
is correctly locked into place.
Insert the brewing unit properly.
Switch off the appliance and
switch it on again via the ON/
OFF button (repeat if
necessary) until standby mode
is displayed.
Switch off the appliance and
switch it on again via the ON/
OFF button ; if this does
not solve the problem, send
the appliance to the service
department.
71 71