Using The Bitholder; Switching On/Off; Cleaning And Maintenance; Cleaning - Parkside PBSA 12 D4 Traduction Des Instructions D'origine

When setting the keyless chuck, a
25 mm bit may remain in the bit
holder (14).
If the keyless chuck (1) does not
engage automatically, turn the drill
chuck ring (2).

Using the bitholder

After removing the keyless chuck (1) you
can use the bitholder (14).
There is a magnet bit holder
15) on the left and right of the
(
housing.
You can attach one bit at a time to
the magnetic bit holder.
1. Insert a suitable 6-point bit in the
bitholder (14). Because of the 6-point
bit holder, it may be that you need to
rotate the bit slightly.
2. Slide the bit right into the bitholder
(14). The bit is held firmly by the duct
and the magnetic bitholder.
3. To remove the bit, simply remove the bit
from the bitholder (14).

Switching on/off

By using the on/off switch (7) you can
progressively control the speed. The longer
you push the on-off button, the higher the
speed.
1. Press the on/off switch (7) to start the
device. The LED work light (8) lights up
during operation.
2. To turn it off, release the on/off switch
(7). When you move the direction
switch (6) to the middle position,
the device is secured against being
switched on.
Cleaning and

maintenance

Contact our Service Centre about
repairs and servicing not described
in this manual. Only use OEM
parts. Risk of injury!
Turn off the appliance and, before
doing any servicing, remove the
battery.
The following cleaning and servicing
should be done regularly. This will ensure
a long and reliable service life.

Cleaning

Do not spray the appliance
with water and do not im-
merse it in water. Electric
shock hazard!
• Keep clean the ventilation slots, motor
housing and handles of the appliance.
Use a damp cloth or a brush.
Do not use cleaning agents or solvents.
You may otherwise irreparably dam-
age the appliance.
Maintenance
The appliance cleaner is maintenance free.

Storage

• Store the equipment in a dry place well
out of reach of children.
• The storage temperature for the battery
is between 0 °C and 45 °C. Avoid ex-
treme cold or heat during storage to en-
sure the battery output is not adversely
affected.
GB IE
29