Use - Cleanmaxx EV-660-S148 Mode D'emploi

EN

Use

PLEASE NOTE!
■ Ensure that there are no larger, sharp objects on the surface which is to be cleaned.
■ Do not use the device when it is connected to the mains adapter.
■ Empty and if necessary clean the dust container after each use (see the "Cleaning
the Device and Accessories" chapter).
■ Switch the device off after each surface has been cleaned as this will considerably
increase the operating time on each battery charge. Charge up the battery after use
(see the "Charging Up the Battery" chapter).
• If the suction performance diminishes, empty the dust container (12) and / or
charge up the battery.
• When the device is switched on or connected to the charging station (23), the
battery status is displayed. If all three battery control lamps (9) are lit up, the
battery is full. The fewer lamps are on, the lower the battery charge.
Floor Vacuum Cleaner
To operate the device as a fl oor vacuum cleaner, the cordless vacuum cleaner and the
turbo nozzle (7) must be inserted in the frame (6) (see the "Assembly" chapter).
1. Take the frame (6) with the cordless vacuum cleaner from the charging station (23).
2. Hold the turbo nozzle (7) with your foot and tilt the frame (6) downwards. This will
release the upright position.
3. The stem of the frame (6) contains the operating buttons (16):
Switch on/off
+ Increase suction power by one level
– Reduce suction power by one level
Switch the brush rotation in the turbo nozzle on/off
Switch on the cordless vacuum cleaner and guide the turbo nozzle (7) over the fl oor.
Switch on the brush for more in-depth cleaning. When the brush is switched on, the
control lamps (10) on the turbo nozzle (7) light up.
4. Fold down the stem (15) to vacuum under furniture. To do this, pull the lever (8) be-
neath the handle (17) upwards. This loosens the joint (1) of the frame (6) and makes
it fl exible.
5. To park the cordless vacuum cleaner from time to time, put the frame (6) into the up-
right position. The joint (1) locks in place when the frame (6) and the turbo nozzle (7)
form a 90° angle (upright position). To release the upright position, hold the turbo
nozzle (7) with your foot and tilt the frame (6) downwards.
22
To allow easy handling,
the joint of the turbo noz-
zle (7) can be moved to the
left / right as well as up and
down.