General Installation Requirements - Sinmag Europe Laminato Mode D'emploi

ENG
To ensure safe work, comply with the following instructions:
1.
Install the machine in compliance with workplace safe work requirements.
2. Don't place the machine near a source of heat and this machine must not be used in
a place where the surrounding environment may have a potential risk of explosion.
3. Use the machine with great care and never be distracted.
4.
Do not wear loose fitting clothing or clothing with wide or open sleeves.
5.
Do not remove, cover or modify the identification plates placed on the machine body.
6.
Do not use the machine as a working surface or area and do not place any objects
on it that are not required for normal working operations.
7.
Do not use the machine with temporary electrical connections or non-insulated
cables.
8. Periodically check the state of the power cable and the cable clamp on the machine
body, have it replaced as soon as is necessary by qualified personnel.
9. Stop the machine immediately as soon as there is any defective or abnormal
operation, a breakage, any incorrect movements, or unusual noises.
10. Before cleaning or carrying out maintenance, disconnect the machine from the
electricity mains.
11.
Use protective working gloves for cleaning and maintenance.
12.
For all extraordinary maintenance, consult the manufacturer or qualified and
authorised personnel.
13.
Do not use water jets or spray to clean the machine.
14.
When sharp accessories are manipulated, use cut-resistant gloves.
3. INSTALLATION

3.1 General installation requirements

NOTE:
It is most important that this machine is installed correctly and that the operation
is correct before use. Installation shall comply with local electrical, fire, health
and safety requirements.
This machine is designed to provide years of satisfactory service. Correct installation is
essential to achieve the best performance, efficiency and trouble-free operation.
3.2 Installation
This appliance shall be installed with sufficient ventilation to prevent the occurrence of
unacceptable concentrations of health harmful substances in the room.
Installations must be carried out by qualified service persons only. Failure to install
equipment to relevant codes and manufacturer's specifications in this section will void
the warranty.
Components having adjustments protected (e.g. paint sealed) by the manufacturer are
only to be adjusted by an authorised service agent. They are not to be adjusted by the
installation person.
It is the responsibility of the owner to supply and arrange for the connection of all
services to the machine.
3.3 Unpacking
On receipt of the machine, carry out the following: Remove all packaging and transit
protection including all protective plastic coverings from outer panels.
4
SINMAG EUROPE BVBA