Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
2.2 Working safety information
The machine must only be used by personnel suitably trained for the purpose and who have
ENG
been trained in the contents of this publication.
To ensure safety, comply with the following instructions:
1.
Install the machine in compliance with workplace safe work requirements.
2.
Don't place the machine near a source of heat and this machine must not be used in a place
where the surrounding environment may have a potential risk of explosion.
3.
Use the machine with great care and never be distracted.
Do not wear loose fitting clothing or clothing with wide or open sleeves.
4.
5.
Do not remove, cover or modify the identification plates placed on the machine body.
6.
Do not use the machine as a working surface or area and do not place any objects on it that
are not required for normal working operations.
7.
Do not use machine with temporary electrical connections or non-insulated cables.
8.
Periodically check the state of the power cable and the cable clamp on the machine body,
have it replaced by qualified personnel as soon as is necessary.
9.
Stop the machine immediately as soon as there is any defective or abnormal operation, a
breakage, any incorrect movements, or unusual noises.
10.
Before cleaning or carrying out maintenance, disconnect the machine from the electricity
mains.
Use protective working gloves for cleaning and maintenance.
11.
12.
For all extraordinary maintenance, consult the manufacturer or qualified and
authorised personnel.
13.
Do not use water jets or spray to clean the machine.
14.
When sharp accessories are manipulated, use cut-resistant gloves.
3. INSTALLATION
3.1 General installation requirements
NOTE:
It is most important that this machine is installed correctly and that the operation is correct
before use. Installation shall comply with local electrical, fire, health and safety requirements.
This slicer is designed to provide years of satisfactory service. Correct installation is essential to
achieve the best performance, efficiency and trouble-free operation.
3.2 Installation
This appliance is to be installed with sufficient ventilation to prevent the occurrence of
unacceptable concentrations of health harmful substances in the room.
Installations must be carried out by qualified service persons only. Failure to install equipment
according to relevant codes and manufacturers specifications in this section will void the
warranty.
Components having adjustments protected (e.g. paint sealed) by manufacturer are only to be
adjusted by an authorised service agent. They are not to be adjusted by the installation person.
It is the responsibility of the owner to supply and arrange for the connection of all services to the
machine.
16
Publicité
Table des Matières
