Protection Class; Installation; Safety Instructions - Burkert PTB 01 ATEX 2175 Manuel D'utilisation

6.5.7.

Protection class

Electrical connection
Appliance socket connection in
accordance with DIN 43650 form C
Circular plug connection M8, 3-pole
2 pressed-in single wires 0.2 mm
(AWG 24)
Rectangular plug connection, 2-pole
Rectangular plug connection, 2-pole
without protective collar
12
Protection class
without with
matching matching
plug plug
connector connector
IP20 IP65
IP65
2
IP20 IP20
english
7.

INSTALLATION

7.1.

Safety instructions

DANGER!
Danger of explosion!
The device is a closed system. It must not be removed.
Risk of electric shock!
• Before reaching into the device or the equipment, switch off the
power supply and secure to prevent reactivation!
-
• Live terminals in the terminal box may cause an electric shock,
short-circuit or explosion. Switch off the power supply. Only then
open the terminal box.
• The connection lines of the electromagnets must be permanently
installed in such a way that they are adequately protected from
mechanical damage.
• Observe applicable accident prevention and safety regulations
for electrical equipment!
WARNING!
Danger – high pressure!
When reaching into the system, there is an acute risk of injury.
• Before dismounting pneumatic lines and valves, turn off the pres-
sure and vent the lines.
• During the installation, make certain the flow direction is correct.
• Observe applicable accident prevention and safety regulations
for pressurized devices.
PTB 01 ATEX 2175
Installation