Safety Instructions; General Information; Intended Use - Becker Centronic SunWindControl SWC62 Notice De Montage Et D'utilisation

The following safety instructions and warnings are intended to avert hazards
and to prevent property damage and personal injury.

General information

•
Always comply with regulations of local energy supply companies as well
as VDE 100 provisions for wet and damp rooms during installation.
•
Only use in dry rooms.
•
Only use original, unmodified Becker parts.
• Observe all pertinent country-specific regulations.
• Dispose of exhausted batteries properly. Only replace batteries with ones
of the same type (see Technical Data).
• Keep people out of the system's range of travel.
•
If the system is controlled by one or several appliances, the system's range
of travel must always be visible during operation.
• Keep children away from control units.
Caution
•
Risk of injury due to electric shock.
• Connections to the 230 V mains must always be per-
formed by an authorised specialist.
•
Disconnect the connecting cable from the power prior to
installation.
•
When connecting the control cables (protected extra-low
voltages), only use cables with sufficient electrical
strength.
•
Device contains small parts that can be swallowed.
The SWC62 must only be used to control sun protection systems.
The connection of external devices must be carried out in consultation with
specialist retailers.
34 - en

Safety instructions

Intended use