Becker Centronic SunWindControl SWC62 Notice De Montage Et D'utilisation page 45

END POSITION
When the sun protection system is fully extended or retracted, this is de-
scribed as an end position.
I-INTERMEDIATE POSITION
The I-intermediate position is a freely selectable position of the sun protection
system, between the retracted and extended end positions. Once pro-
grammed, this position can be travelled to from the retracted position.
To do so, press the EXTEND button briefly twice in succession.
For venetian blind operation, any tilt which has been set is automatically car-
ried out following the I-intermediate position.
II-INTERMEDIATE POSITION
The II-intermediate position is a freely selectable position of the sun protection
system/venetian blind between the retracted and extended end positions. With
this function, you can tension the fabric of your sun protection system.
With the venetian blind, the slats can be tilted.
To do so, press the RETRACT button briefly twice in succession.
WINTER OFF/ON
If the WINTER ON function is activated, no automatic or manual drive com-
mands will be executed.
WIND MONITORING
The threshold value for WIND is reset to 04.
The wind value can be set to anywhere between 01 (little wind) and 11 (very
windy).
The display indicates the current wind value and the wind value to be set. The
value to be set flashes.
If the lower wind threshold value is violated for a minimum of 15 mins, drive
commands can be executed again.
TEST mode
This mode lets you test the functionality of the sensors. If Test mode is active,
you will see TEST on the display.
The delay times are shortened in TEST mode.
Language selection (ENGLISH)
Here you can select your own language.
45 - en