Safety Instructions; Designated Use - Becker Wind-Automatic WA10 Notice De Montage Et D'utilisation

Warning!
Please keep the instructions in a safe place!
• Risk of injury through an electric shock.
• Terminal connections to a 230 V network must be carried out by an
authorised electrician.
• Before assembly, disconnect the power lead from the supply.
• The provisions of the local public utilities and stipulations for wet and
damp rooms in accordance with VDE 100 are to be observed when
the system is connected.
• Use only unmodified Becker original parts.
• Keep persons away from the systems guide track.
• Keep away from controls.
• Please comply with national stipulations.
• If the system is controlled by one or several devices, the system
guide track must be visible during operation.
• Only types of cable with sufficient electric strength can be used for
connecting control cables (protective low voltages).
• The equipment contains small parts that could be swallowed.
The WA10 may only be used for the control of sun protection systems with a
WindSensor WS10 or a Centronic SensorControl SC71 and a standard notch
switch.
This device may only be used in connection with equipment from other manu-
facturers following consultation with your local retailer.
If the WS10 is used for any purpose other than that stated above, this shall be
regarded as non-designated use.

Safety instructions

Designated use

de
en
fr
nl
11