Oven Door Removal; Replacement Of The Oven Light - BORETTI BPOP-60 Notice D'emploi

Oven door removal

Make sure that:
• T he oven is cool and power to the oven has been turned
off before removing the door. Failure to do so could result
in electrical shock or burns.
• T he oven door is heavy and fragile. Use both hands to
remove the oven door. The door front is glass. Handle
care-fully to avoid breakage.
• G rasp only the sides of the oven door. Do not grasp the
handle as it may swing in your hand and cause damage or
injury.
• F ailure to grasp the oven door firmly and properly could
result in personal injury or product damage.
To remove the oven door (see Fig. 10):
1 Open the door completely.
2 Lift up the hinge bracket (1) into the slot (2).
3 Hold the door firmly on both sides using both hands and close the door.
4 Hold firmly; the door is heavy.
5 Place the door in a convenient location.
To replace the oven door (see Fig. 10):
1 Insert the upper arms (3) of both hinges into the upper slots (6) and the
lower arms (4) into the lower slots (7). The recesses (5) must hook on the lips (8).
2 Move the hinge brackets (1) back down into position.
3 Close and open the door slowly to assure that it is correctly and securely in pla-
ce.
66
WARnInG
Fig. 10

Replacement of the oven light

WARnInG
Make sure that:
• T he oven and lights are cool and power to the oven has
been turned off before replacing the light bulb(s). Failure
to do so could result in electrical shock or burns.
• T he lenses must be in place when using the oven.
• T he lenses serve to protect the light bulb from breaking.
• T he lenses are made of glass. Handle carefully to avoid
breakage. Broken glass could cause an injury.
1
(230V - 15 or 25W)
2
1
Fig. 11
1 Turn off power at the main power supply (fuse or breaker box).
2 Remove the lens (1) by unscrewing it.
3 Remove the light bulb (2) from its socket (3).
4 Replace the bulb (2) with a new one. Avoid touching the bulb with fingers, as oils
from hands can damage the bulb when it becomes hot.
5 Use one with the same Volt and Watt (see Fig. 11).
6 Screw the lens (1) back on.
7 Turn power back on at the main power supply (fuse or breaker box).
NL
FR
EN
DE
3
67