Electronic Control; Control Panel Description; Setting The Minute Minder - BORETTI BPOP-60 Notice D'emploi

electronic control

Control panel description

The oven control panel is made by three displays and eight touch sensor keys.
The displays show:
 Time.
 Temperature.
 Function.
c
min
A B
 [A] Touch this key to enable the fast preheat
 [B] This key is used to set the clock, the minute minder and the buzzer volume.
 [C] This key is used to set the cooking duration and the stop time.
 [D] Touch or hold this key in order to decrease the displayed value.
 [E] Touch or hold this key in order to increase the displayed value.
 [F] Touch this key to switch the oven lights on/off.
 [G] This key is used to set the oven functions and the related temperature.
 [F] Touch this key in order to switch the oven on and make it available for any
activity or touch it to switch the oven off when it's active.
Power-up
At every power-up, wait for about 7 seconds until a triple beep sounds: the special
touch circuit performs a self-calibration and it's important to avoid any touch during
this phase.
The latch mechanism runs an automatic self-test: the oven door locks and unlocks.
This operation takes about half a minute. The lock symbol on the temperature
display turns on:
1. It flashes while the action is in progress.
2. It's steadily on when the door is fully locked.
3. It's off when the door has been unlocked.
Do not try to open the door until the lock symbol has disappeared.
The control shows the time of day blinking, set at 12:00 as the initial value. The
time increases every minute, all oven operations are inhibited until the time of day
is set.
56
C D E F G H
Fig. 8
Setting the time of day
The time of day is always displayed in the 24 hours format.
Touch the [B] key (clock/timer) until the word "hour" appears on the clock display.
Wait until the time value appears then touch [D]/[E] keys in order to set the proper
value. Hold the keys to fasten the decrease/increase operations
After a few seconds the whole time of day value starts flashing: wait until the new
time of day is steady.
Fig. 9a

Setting the minute minder

Touch the [B] key (clock/timer) until the word "bell" appears on the clock display.
Wait until the time value appears again then touch or hold [D]/[E] keys to edit and
modify the value. Hold the keys to fasten the decrease/increase operations.
The standard value is 30 minutes, it's possible to modify it in the range between 0
and 240 minutes. The timer has no influence on the oven activities and can be set
also when the oven is off.
The time of day is displayed with priority in any case, the bell symbol
left corner of the clock display shows that the minute minder is set.
When the time expires, the symbol flashes and the buzzer sounds a warning
sequence (two short beeps repeated every 3 seconds) to recall the user attention.
Touch any key to stop it.
The buzzer stops in any case after a 5 minutes time-out.
Setting an oven function manually
1. Touch the [H] key (On/Off) to awake the oven and make it ready for use.
A square appears on the icon display and the "On" writing on the clock display.
2. Touch the [G] key (function/temperature) in order to select the desired
cooking mode. The clock display shows "Pr00" which correspond to the Light
mode.
3. Touch [D] or [E] keys (-/+) in order to browse the list of the available
functions. The icon display shows the oven elements used in every function, the
temperature display shows the preset temperature per every function.
4. Touch the [G] key again in order to change the temperature. The
NL
FR
EN
DE
in the upper
57