Metrix CX 1651 Manuel De L'utilisateur page 160

Calibrateur multifonctions CX 1651
[: LEVEl]
[: IMMediate]
[: AMPLitude] (?)
: RJUNction (?)
: TYPE (?)
: PRT
[: LEVEl]
[: IMMediate]
[: AMPLitude] (?)
: TYPE (?)
: NRESistance (?)
MEASure subsystem
This subsystem allows to control the internal multimeter of CX 1651 calibrator. It sets the multimeter's functions
and reads measured values.
Keyword
MEASure
?
: CONFigure
: VOLTage
: CURRent
: MVOLTage
: RESistance
: FREQuency
: TEMPerature
: RTD
: TYPE (?)
: NRESistance (?)
: THERmocouple
: TYPE (?)
: RJUNction (?)
: SGS
: VOLTage (?)
: OFF
TESTer subsystem
This subsystem allows to control features of CX 1651 calibrator when used as tester. It starts selected test
procedure and reads its result.
Keyword
TESTer
: RUN
: RESUlt ?
Operation complete
*OPC <cr>
This command sets the OPC bit in the ESR (Event Status Register) when all pending operations are complete.
160
<DNPD>
<DNPD>
<CPD> { B | E | J | K | N | R | S | T }
<DNPD>
<CPD> { PT385 | PT392 | NI }
<DNPD>
Parameters
<CPD> { PT385 | PT392 }
<DNPD>
<CPD> { B | E | J | K | N | R | S | T }
<DNPD>
<DNPD>
Parameters
<DNPD>
Manuel de l'utilisateur