Télécharger Imprimer la page

Metrix CX 1651 Manuel De L'utilisateur page 143

Calibrateur multifonctions

Publicité

Les langues disponibles

Les langues disponibles

29. Temp.unit .... xx
30. Phase.unit .... xx
31. Output 140-41 .... xx
This parameter allows the output terminals to be selected. AUX means that the output signals are present only at
the cable adapter's terminals, PANEL means that the output signals are present only at the front panel.
32. Meter average .... xx
Displays the number of measurements taken before the average value of build-in multimeter is displayed
(integration constant). UP, DOWN display buttons can be used to select a value in the range of 1 to 20. The
higher the value, the longer the calibrator needs to measure a value, but displayed value is more stable. If 20 is
set, one measurement takes approximately 2.5 s.
33. Interface .... xx
34. GPIB address .... xx UP/DOWN
35. RS232 baud rate .... xx
36. Handshake .... xx
Indicates the communication handshake. Display buttons can be used to select OFF or Xon/Xoff. Perfect
communication with the PC requires equal values set at the PC and the calibrator.
37. Keyb.beep .... xx
38. Keyb.volume .... xx
39. Brightness .... xx
40. Rotary change .... xx ON/OFF
This parameter controls the range of functions of the potentiometer. If ON is set, the potentiometer can move the
cursor both to the left and right (← and → symbols) and up and down (∧ and ∨ symbols). If OFF is set, the
potentiometer can move the cursor up and down only (∧ and ∨ symbols).
41. Switch polarity .... xx ON/OFF
This parameter controls the function of the built-in relay. If ON is set, the relay is closes before the test. If OFF is
set, the relay is opens before the test.
Manuel de l'utilisateur
o
C/K
o
/cos
AUX/PANEL
UP/DOWN
GPIB/RS232
UP/DOWN
OFF/Xon-Xoff
ON/OFF
UP/DOWN
UP/DOWN
Calibrateur multifonctions CX 1651
143

Publicité

Chapitres

loading

Produits Connexes pour Metrix CX 1651