Metrix CX 1651 Manuel De L'utilisateur page 100

Calibrateur multifonctions CX 1651
The function of the potentiometer can usually be performed by the cursor buttons. The central button is used to
confirm the selection (ENTER).
4 Numeric keyboard
The keyboard allows the entry of numeric values on the display. The central button is used to confirm the
selection (ENTER). CANCEL button can be used to cancel the entry.
5 Function buttons
Function buttons can be used to call-up the functions of the calibrator directly. The following buttons are
provided:
function
DC voltage
AC voltage
DC current
AC current
resistance / capacitance
power / energy
frequency
internal multimeter
simulation of temperature sensors
After the function mode is changed, the parameters of the respective function are restored. If the respective
function was never used, the calibrator resets to its reference values. Reference values for individual functions are
listed below.
function
DC voltage
AC voltage
DC current
AC current
resistance
capacitance
power
energy
frequency
multimeter
simulation of temperature sensors
cold junction temperature of TC sensors
*1
U = 100 V, I = 1 A, PF(power factor) = 1 LA, active power is displayed in Watts
100
button
U / DC
U / AC
I / DC
I / AC
R – C
P – E
F
METER
T
value parameters
10V - -
10 V f = 1000 Hz
100 mA - -
100 mA f = 1000 Hz
100 kΩ
1 µF
100 W f = 100 Hz
1000 Hz U = 1 Vsym
10 V DC voltage
o
100 C Pt 100/1.385, ITS90
o
23 C R
*1
Manuel de l'utilisateur