Error Messages - Metrix CX 1651 Manuel De L'utilisateur

Error messages

If an error occurs during the calibrator's operation or control, error message is displayed on the display. Errors
can be caused by:
•
incorrect control using the front panel, i.e. attempts to force a prohibited mode, e.g. setting an out-of-range
value, overloading of output terminals etc.,
•
fault of the calibrator, e.g. internal communication error during the communication between individual
functional blocks,
•
incorrect control using the GPIB or RS-232 bus.
Below you can see a sample error message which appears when too large value is attempted to set up. All error
messages are displayed in the center of the display.
The following table lists all error messages, their meaning and simple troubleshooting.
Manuel de l'utilisateur
Calibrateur multifonctions CX 1651
145