ROBBE 3D GYRO Notice De Montage Et D'utilisation page 11

2. If you are in a real hurry, here are brief instructions for getting the gyro working:
· Connect the system as shown in Sketch 1
· Switch on the transmitter
· Switch on the receiver
· Do not touch the model or 3-D gyro for about 10 seconds while the 3-D gyro carries out
its zero calibration procedure.
· When ready -> tail rotor servo runs to starting position and the red „Ready" LED on the
3-D gyro lights up
· Move channel 5 slider to one end-point
· Move tail rotor stick to one end-point and release it
· If servo moves back to its original position -> Normal mode
· If servo stays in the end-point position -> Heading Hold mode
· Slider 5 acts as change-over switch between the two modes, and is also used to adjust
gyro gain (sensitivity).
· At centre position:
· At position direction: I
· At position direction: II 0% - 100% „Heading Hold" mode
3D GYRO english
0%
0% - 100% „Normal" mode
I
100 %
LINEAR
100 %
II
Sketch 2
Normal Modus
Normal mode
0 %
Heading Hold Modus
Heading Hold mode
11
No.
8065