EUROM Mon Soleil 300 Manuel D'utilisation page 63

12 OK
13 TEMP
14 + or –
15 OK
16 TIME ON
17 + or –
18 OK
19 TIME OFF
20 + or –
21 OK
Timer setting(s) is/are entered; the ambient temperature will appear on the
display after three (3) seconds.
Attention (1): The timer setting(s), which you make under 'once only (01)',
should be made for the current week. On Sunday (day 7) at 24.00, all 'once only'
setting(s) are set to 'non-active'. Therefore, a timer setting for Saturday that you
made on Tuesday will work, but a timer setting for Tuesday that you make on
Saturday will not work!
Attention (2): If a timer setting with number 01 was made for this day, you must
manually set the next timer setting for this day to 02 using the + button, otherwise
the timer setting 01 will be overwritten.
Attention (3): Start & stop times can only be entered in whole hours (not in
minutes).
Removal of timer settings using the remote control
Removing all timer settings
1. Press the WEEK button for three (3) seconds, until the display shows the
flashing UU.
2. Pressing the C (Cancel) button will erase all timer settings.
Removing all timer settings of a specific day
1. Press the WEEK button for three (3) seconds, until the display shows the
flashing UU.
2. Press the SET button and the display will show your flashing selection of
ON/OFF (timer on or off).
The selected
number
HP flashes
The selected
temperature
HE flashes
The selected start
time
HF flashes
The selected stop
time
sequence of the numbering is not
important [see Attention (2)].
Set the desired temperature (0 °C to
37 °C). The default setting is 20 °C.
Set the desired start time from 00.00
to 23.00 [see Attention (3)].
Set the desired stop time from 00.00
to 23.00 [see Attention (3)].
63