EUROM Mon Soleil 300 Manuel D'utilisation page 57

 Choose a firm, even, vertical wall made of heat-resistant material on which to
hang the heater.
 Define the position of the suspension frame: the frame should be mounted
horizontal to the wall. Position the suspension frame in such a manner that the
minimum
distances stated in the drawing above are guaranteed when installing the heating
panel in the suspension frame. Mount the suspension frame with the correct side
upwards (see the 'This side up' label on the suspension frame).
 Mark where the 4 holes need to be drilled: do this at the correct distance and
perfectly level with respect to each other.
 Drill 10mm holes in the marked places and insert the cotter bolts into the holes.
 Screw the suspension frame immovably against the wall.
 Hang the heating panel in the suspension frame: the panel's suspension knobs
through the eyes in the suspension frame.
 Slide the panel as far as possible to the right side and lower it as far as possible.
Now the panel is suspended securely.
 To remove the panel from the wall, you must slide in the opposite direction and
lift, until the knobs are in front of the eyes again. Now you can take the panel
off.
57