EUROM Mon Soleil 300 Manuel D'utilisation page 62

Attention:
Attention:
Step Press
button:
1 WEEK (3 sec.) UU flashes
2 SET
3 + or –
4 OK
5 SET
6 OK
7 SET
8 + or –
9 OK
10 EDIT
11 + or –
However, the timer data that were entered previously (ON and
OFF times of the week timer) are stored. To avoid
misunderstandings, the week timer is automatically set to OFF in
case of turning the heater off using the main switch or removing
the plug from the socket. Otherwise, the panel would switch on
and off at the wrong times.
Switching the week times on again is described below.
Please note that the abovementioned does not apply when using
the Eurom Smart APP. The APP updates the time automatically
and therefore, you do not have to enter the time manually.
If in the time setting mode no button is pressed for five (5)
seconds, the timer-setting mode will stop and you will have to
start all over again.
All timer settings – maximum 28 settings: seven (7) days
multiplied by maximum four (4) settings per day – are processed
consecutively. therefore, make sure that they do NOT contain
contradictions.
The display
shows:
ON/OFF flashes
UU
01 or 99 flashes
UU
U1 flashes
U1 to U7 flashes
The selected day
01 flashes
Explanation:
Select:
+ = ON: Timer on (on the set times,
the heater will automatically switch
on/off)
– = OFF: Timer off (on the set times,
the heater will not automatically
switch on/off)
Select:
+ = 01: All timer settings are
executed only once
– = 99: All timer settings are
executed endlessly [see Attention
(1)].
Select the day of the week (1 =
Monday, 2 = Tuesday, etc.) for which
you want to make a timer setting.
You should give a number (1 to 4) to
this day, because you can only make
four (4) timer settings per day. The
62