entering the data into the Smart Timer. The Smart Timer data is not visible on
the heater. Regularly check in the App whether the entered Smart Timer data
are still correct.
You can consult an elaborate Eurom Smart App user manual with the QR code
below:
or on the website: http://www.eurom.nl/nl/manuals
Turning the WiFi connection on and off
The heater should be ON, but should NOT heat and therefore, there is no
-
heating symbol visible on the heater's display. (Do this by setting the
temperature lower than the ambient temperature using the – button, for
example.)
Press the ON/OFF button for three (3) seconds to toggle between WiFi ON and
-
OFF.
WiFi symbol flashes on the display: WiFi connection is ON.
No WiFi symbol on the display: WiFi connection is OFF.
Attention: As soon as there is a WiFi connection, you can no longer use the timer
function on the remote control, which prevents contradictions.
As soon as there is a WiFi connection, the APP updates the time automatically and
therefore, you do not have to enter the time manually.
Safety feature
Anti-tip protection
If the heater is horizontal for more than 20 seconds, the stove switches off
automatically. Put the stove upright again, switch it off and on again and the stove
will resume operation.
Overheating safeguard
In case of internal overheating, the overheating safeguard will switch the heater
off. This may occur if the heater cannot give off enough heat or if it cannot draw in
enough fresh air. As mentioned above, this is generally caused by (partially)
covering the heater, or installing the heater too close to a wall or something
similar. In case of overheating, switch off the heater and unplug. Give the heater
time to cool down, remove the source of the overheating and use as normal. If the
problem persists or if you have not been able to trace the source of the
overheating, turn the heater off immediately and unplug. Contact a servicing point
to have the heater repaired.
Cleaning and maintenance
Keep the heater clean. Switch off the heater, remove the plug from the socket and
allow the heater to cool down before cleaning or carrying out maintenance work.
66